Quote Originally Posted by Petra View Post
It's more that the heads of the screws are out of spec than it being a weak material or D-Tek providing the incorrect hex key with the block... if you look at the base photo on our store site, you'll note that I ended up slotting all four screws with a Dremel so that I could loosen and tighten them with a standard flat-head screwdriver. Yay for manufacturing stuff overseas
Haha, nice.
Once I got the hex head screws out I cut down some other screws I had, they work perfectly!

(btw, don't worry about those little dots on the copper, it's just from air bubbles that got trapped under the plastic piece that was on there... I took it off then put it back on. I'll just have to clean it)

-Parker