dayam uncle jimbo,
You sure know a ton about TEC's.
Well the original plan was having the hotside and cold side seperated. Never in the design did i plan to have them both on 1 loop.
Originally the cold side was to have a radiator. My idea was to take the coolant as closes to ambient as possible, and then use the TEC's to push me slightly into sub ambient.
Well problem came, radiator is no longer that good thing i was hoping for. The capacity for water to hold that much energy was what screwed my thoery up.
So now its going to be a straight TEC setup, no radiator except hotside. The cold side as i said will be connected to a reservoir, where the water inside will be continuously circulated. The water in the chilled reservoir will then be fed to the system.
Or i can just drop that unit inline on the blocks only and run it solo.
If i was to use a lets say 40mm x 2 radiator, you think this would hurt my performance on the cold side? i dont want to dip too far into sub ambient. I really hate preping things for condensation.
Something like this?
http://www.performance-pcs.com/catal...ducts_id=22275
or even this?
http://www.performance-pcs.com/catal...ducts_id=22597
*
Reply With Quote
Bookmarks