vSPP done and done. still just getting started with testing though to see how much is needed to get past 560~565FSB benchable with P1/P2 enabled...but can confirm the mod Dinos posted works like a charm with 20K ohm VR. it will raise voltage from what is selected by 0.05v with a 20K ohm VR so just keep that in mind...

Quote Originally Posted by 3oh6
vSPP
Dinos post was again bang on and the soldering point was correct. Measured resistance of the circuit was 776 ohms so I went with a 20K ohm resistor. After the mod, resistance dropped to 745 ohms and voltage was 0.06v higher than selected according to the BIOS monitor. I still don't have a confirmed vSPP read point on the board so I am just going with the BIOS reading as it raises with lowered resistance. Very easy to solder to the IC leg and a perfect mounting point, as seen, alongside the I/O tower. Just did it so no testing on whether it will help FSB clocking past 575FSB with P1/P2 enabled.



all vmods that have been tested working can also be found in my MB OC Report.