**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[gmannji]

ok guys i think i have a problem here. my system was running fine yesterday until i restart, it just wont post. c1 error. but then i test it using single module it turns out one of the ram cannot be used. then i did a cmos reset. unplug the battery for 12 hours then plug everything back. still no post with both rams installed.

then i press the reset button a few times and suddenly it post. but cannot oc the rams at all. only 1 module can undergo oc. then i did a memtest with both module installed, it was very very slow. 10 minutes running and test no1 still hadnt finished. is this memory related problem or the board?

i didnt oc the ram much. was running at 3.4ghz (425x8) 5-5-4-10 @ 1066 with 2.05v only. but it was quite hot during benching. im using team xtreem 2gb pc6400 cl4. and my ram settings are almost the same from the anandtech review.

owh yea one more thing. how do i get this board to 3.6ghz? have some difficulties wtih vtt and gtl