Quote Originally Posted by Uncle Jimbo View Post
I like to design these to use an off the shelf $40 PC supply and not a $200 lab supply. OC work is expensive enough without going too exotic. Getting a supply that can deliver 30A at 12V continuous is a lot harder and more expensive than one that will do 22-25.
You see im the oposite.

When i got something in my head that i want, i go out and get whats needed.

The only thing im regretting right now is that i didnt grab the 600W meanwell like nol told me to. Now looks like i might need to grab another 320W meanwell.

Okey anyhow from my understanding and thank you jimbo, you've been an valuable resource to me in the past 2 threads, you think i should keep the hotside on air?

Let me rephrase this question after you know some background.

1. i have more excess h2o crap then air crap. So if i was to go out and get sinks, i would need to buy everything from ground up. The blocks are custom by Martin, so i would need to send out a block to a millist, and have him mill me a counter top where i can sink my screws in. Ummm... sounds like too much work.

2. The pump i designated for this system is still unknown. Most likely a DDC-3.2 for the cold side. The hotside i already picked up the DB-1. Since the loop was to be small to begin with, if your saying i want the hotside at a higher delta, i could always connect it to an MCR220. Kinda lost on this. But if your saying i want to keep a 50C on the hotside, then i figure MCR220 with a heat load of around 300-400W will probably make my coolants ~ 35-40C on a small radiator like that.

Blah, if i need to go out and get the sinks, man... No comment. :\