Official DFI LanParty UT X38-T2R(and LT) Discussion/Review/Overclock/Guide Thread

[zsamz_]

I've been running this mb throught the ringer, for some "forumwars", and when I get the c1, due to too much or too little of something, I just turn it off/ restart it. Goes through a couple of startups then boots sometimes. If it doesn't, reset the cmos, and reload one of the "saved" bios configs.
Sometimes it hangs on "52", then I have to reset/cmos.

set memory subtimings dont assume auto is ok
in fine delay set timings dont use auto use relaxed n work your way up

i found clunk's gtl setting way better board is more stable n more responsive but gets hotter
for 1.52 cpu vtt
gtl1:125
gtl2:120
gtl3: 95
heres another chart