Quote Originally Posted by Waterlogged View Post
The flow test done here is only half the story, wait for the thermal test to get a clear picture of how well it actually works.
Working on it, but I'm probably going to start with the PA120.3 first since I have all those beautiful C/W curves to compare results with that Bill Adams did. Built most of my radiator stand this evening, I think I'm going to wire in 8 air inlet sensors, two for each 120mm fan, then I won't have to mess around with install sensors on the radiator every time.

In the end, I'm thinking

Air in = 2each sensor x 120mm fan
Air out = 1each sensor x 120mm fan
Water in = 1each sensor
Water out = 1each sensor

For a total for 14 sensors, I figured I would put the crystalfontz to work with it's 32 channels of available sensors. I don't have an environmental chamber, so I figured the more air in sensors the better.



On to wiringing lots o sensors...