Quote Originally Posted by Jorlen View Post
What capacity does you fans run at to get the current temps?
And where on the coldside and hotside are your temperature probes attached?

Your results are really good, and the heatpipes seem to be working just fine.
The fans are at 12V, but I'll be dropping them all to 7V when everything is said and done. When I was testing the module with no load, the hotplate temerature went up 3C as I dropped the fan voltage to 7V.

You can see the cold plate probe in the insulation picture. The hot plate probe is in the middle of the plate just between the corner edges of the TRUEs