Quote Originally Posted by TsvetanVR View Post
Hey all! I have a really strange issue.. With my P35-DS3P rev2 and my E8200 I can go up to 8x575 (4600) good for benching. The thing is that I do it with default MCH/FSB voltages. I can't get anything above 4600 stable at least for super pi though..... no matter the fsb/mch voltages... and if I rise the voltages even a bit I can't even run super pi on 4600mhz either... something is not right.... Haven't encountered a problem like this before, any ideas? I'm going to try this F10 bios now, let's hope it will fix this "issue" so I can continue overclocking this beastie
P.S. My northbridge is watercooled so we can eliminate the heat as a cause..

Have the same issue on my DS4, when FSB volt is anything else than Normal, i get errors in orthos blend from ~460fsb and up, when normal is selected 535fsb is fine.

I have measured with a multimeter on the board, and the Normal volt is 1,1volt