The Maximus Formula Thread - Help/OCing/Guide/Rampage conversion

[iadstudio]

hi there i have one question:
i have asus maximus formula 1004 with G.Skill F2-8000CL5D-4GBPQ but when i try to set fsb higher of 266 cause error on goldmemory test with other memory not have this is problem...i have tried many setting fsb voltage 1.5 nb 1.6 trfc high 60 80...but after 40min the mem cause error... Any of you know how I can resolve? thanks very much

You'll need to post your bios settings.

[me3850]

q6600 vid 1.3125

Extreme Tweaker
Ai Overclock Tuner : Manual
OC From CPU Level Up : AUTO
CPU Ratio Control : Manual
- Ratio CMOS Setting : 8
FSB Frequency : 438
FSB Strap to North Bridge : 333
PCI-E Frequency: 100
DRAM Frequency: DDR2-1052
DRAM Command Rate : 2T
DRAM Timing Control: Manual
CAS# Latency : 5
RAS# to CAS# Delay : 5
RAS# Precharge : 5
RAS# ActivateTime : 15
RAS# to RAS# Delay : auto
Row Refresh Cycle Time : auto
Write Recovery Time : auto
Read to Precharge Time : auto

Read to Write Delay (S/D) : auto
Write to Read Delay (S) : auto
Write to Read Delay (D) : auto
Read to Read Delay (S) : auto
Read to Read Delay (D) : auto
Write to Write Delay (S) : auto
Write to Write Delay (D) : auto
DRAM Static Read Control: auto
Ai Clock Twister : auto
Transaction Booster : auto

CPU Voltage : 1.43125
CPU PLL Voltage : auto
North Bridge Voltage : 1.45 or i have try 1.6 nothing
DRAM Voltage : 2.02
FSB Termination Voltage : auto (1.52)
South Bridge Voltage : 1.5
Loadline Calibration : enable
CPU GTL Reference : 0.63
North Bridge GTL Reference : 0.67
DDR2 Channel A REF Voltage : auto
DDR2 Channel B REF Voltage : auto
DDR2 Controller REF Voltage : auto
SB 1.5V Voltage : 1.5

NB LED Selection : NB Volt
SB LED Selection : SB Volt
CPU LED Selection : CPU VOlt
Voltiminder LED : enable

CPU Spread Spectrum : Disabled
PCIE Spread Spectrum : Disabled

Advanced CPU Configuration
CPU Ratio Control : Manual
- Ratio CMOS Setting : 8
C1E Suppport : Disabled
CPU TM Function : Disabled
Vanderpool Technology : Disabled
Execute Disable Bit : Disabled
Max CPUID Value Limit : Disabled

have try pdf setting of gskill 333 fsb 266 strap and 2.0v error but i try 266 fsb defalut (q6600) and ram at 1030~ work good no error or try 250fsb and 1000mhz ram work good when try 333 strap 266 ram 1002mhz error ect 400 400 error 333 333 error.... i try many software prime occt memtest and other but no error for 24h but with this software goldmemory after 40m have error... In fact I have several crashes in games and other unusual things

sorry for my bad english :p