*Official Retail G0 Q6600 Overclocking Thread*

[Kyo`]

I guarantee you cannot complete 32M calculations of super Pi at that low of a voltage. My Q6600 has a VID of 1.225. I could boot and run at the same voltage but it wouldn't pass any real benchmarks.

Well being rock stable on 3.6GHz and 1.28v isn't really impossible and I'm sure he can do it, considering the fact that he has a VERY rare chip with a VID of 1.200v. Actually, never seen a second one with that kind of VID.
I'm sure he can post some nice screenshots of not only 32M SuperPi but 8H+ Prime95 Small FTT's since I know he has them.

I'm personally less lucky, but still my chip can do 3.6GHz rock stable on 1.32v, but my board is limiting me a little so I'm keeping it as in my sign below

And tbh, considering 32M SuperPi stable is a little too soon. Errors can pop out even after 3H of Small FTT's on Prime95. In my opinion, 8H+ and more can be considered stable.