Official GIGABYTE X38-DQ6/X38T-DQ6 Info/BIOS Thread

[Tabs]

Guys I have just got some G.Skill 1066 ram 4gb kit and I am running 400 mhz fsb for 3.6ghz.

For the life of me I cant get a 1-1 ram to fsb ratio and getting poor Everest results because of it, at the moment I am running the D strab I think to get 1066 or was it be I cant remember. Has any one got any ideas on how I can keep my cpu @ 3.6 and get my ram running at 1-1 for good read write speeds?

I am running the latest F8 final bios.

I have the G.Skill DDR2 1000 4GB kit and have the exact same issue - can't run 1:1 with my Q6600 with anything other than the original F3 BIOS. I posted about it probably 20 or 30 pages back.

Were you able to figure this out at all? I'd love to be able to use the newer BIOSes, but if I do I get instant instability, memtest errors etc at 1:1. This is at stock CPU speed and what should be a very large underclock for the memory since it only has to run at 266 to be 1:1.

With the later BIOSes it'll actually run stable at higher than 1:1 though, which just doesn't make any sense at all to me.