**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[RPGWiZaRD]

RPGWiZaRD, can you post your full voltages and timings to get 8x500?

Thanks

Certainly, as I had the voltages written up on a note here on my table in case I'd lose the settings and forget them.

CPU: 1.4250v (1.34v in windows due to old bios v14 as mentioned above)
DDR2: 2.200v
VTT: 1.27v
MCH: 1.37v
ICH: 1.05v
ICHIO: 1.55v
DDR2 Ref voltage 0%
CPU GTLREF 0&2: 67%
CPU GTLREF 1&3: 67%

DDR2 timings are IMO very tight for 24/7 but that's due to great micron D9GMH sticks:

tCL: 4
tRCD: 4
tRP: 4
tRAS: 8
tRFC: 25
tWR: 10
tWTR:10
tRRD: 5 (could use down to 3, but saw absolutely no performance improvement, in fact it was more the opposite I lost some B/W, but we're talking very minor differences)
tRTP: 5 (same as above ^)

Since MemSet isn't supported with this mobo I can't mess with tREF or Performance Level but they're both on suitable values anyways, performance level = 7 which is the lowest these sticks handles and tREF = 2600T, not the fastest but should be ok.

Been using settings above since January sometimes without any signs of CPU degration despite really using the minimum required vcore for this to pass OCCT for example.