Tried price matching but no-go.

Will only price-match "reasonable distance" which is about 60mi, or maybe within the state if you're lucky.

I bought one anyway.

Great case, but it is noticeably lesser than the Lian-Li's I've used.

Some bullet points:

Good
Very light, comparable to my antec900 at considerably larger size
Very big, I've got a shot of it next to my 900 I'll post later... lots of room in here.
Looks nice, outside and in. Metal is thin and light, but not flimsy or cheap looking.
More than enough room for watercooling without mods, I've got an mcr220 stuffed inside there at the moment, and with my non-modular PSU it's a bit crowded and warm but it works for a temporary setup. 10 minutes with a jig saw or hole saw and you could have a nice W/C loop in this.

Bad
Door is kind of cheap on the front, squeaks when you open it... can't seem to get it to stop even w/ a bit of oil.
Power/Reset switches are cheap, and squeak. These are virtually the only plastic in the whole case though.
Mediocre air flow at best. A full tower case with only 2 120mm fans? You've got to be kidding! I'm going to be putting in AT LEAST 2 more before I'm satisified. With my 680i the case gets toasty fast, and the northbridge & mosfets don't like that much heat.
GPU fan is awkward, would've much preferred a "true" vent fan, one that blows out the door rather than a small slot in the back of the case.

Verdict:
Great case for the coin, easily the best sub $100 case I've ever worked with. Has a few minor flaws regarding air flow, but a bit of modding can really make this case shine.