Phenom 9500 w/ MSI K9A2 Platinum

[justapost]

On a side note, while underclocking using MSR values, have a look at this using decimal multiplier and DID. Very very very slow, took long to save a basic 200KB image, about 45 seconds.
Lowest underclock? Quite low that, it crashed very soon after the 1M run due to changing volts past 0.850/1.038. Power for that idle and load differed 2W AC.

Thanks for the update, thought higher DID's than one (2x) did not work. Tried 600MHz with success. 300MHz also works but it's too slow.
For the record, 0.85V VID was lowest stable for you, no matter what freq?

Update:
broke 100W ground here

96.3W AC idle

100MHz (0x48009500)


Can switch between 100MHz/0.625V and 2.6GHz/1.3625V via reg c0010062h without problems.

UPDATE: 500MHZ/0.7V is somewhat comparable to by old celeron laptop at 600MHz, still onyl 97W AC consumption in idle. I like the higher DID's.