Quote Originally Posted by jmpage2 View Post
I took the CMOS battery out over night and it still won't POST. Hopefully it's just the memory that's tanked, I'd hate to have to replace my BX2.

I will have to see if I can scrounge a stick of low speed 1.8V RAM to test with. In the event that I have to buy new RAM which 2GB modules are compatible with the BX2? There are a lot of posts around the Internet that indicate many/most 2GB modules are not compatible with this board. I might just go the 4X1GB route if that's easier to run. I am running 32 bit Vista and won't be able to address more than 3.x GB of RAM in any event.
You try getting into "maint" mode with the jumper??? I also had issues with my board with a physics card installed, after a power loss, it would only boot after i removed it from a pci slot... You may want to try and remove any pci cards and see if it boots.... I actually sent my board back for a RMA untill i found this issue out....