I got a new problem.

Just bought OCZ Reaper PC8500....

So they will post and push beyond 1100mhz with a very LOW FSB and a high divider like say 350 but if I run my fsb at 426 with a divider which results in 1066 for the ram it wont post.

I always ran 430FSB with a 1:1 divider on a set of old Patriots 5300.

However with these 8500 I can only run at 1:1 at FSB @ 430, making the ram run @ 430...Which is what, nearly 100mhz underspeed....And if I set the divider to 1066 then it just wont post.

I tried whole range of timings and volts. I did the Vdim mod, giving me 2.35 under 2.1 in bios.


Any suggestions?