Hi everyone,

I've got this mobo two weeks ago and I'm totally lost with the bios settings. I've read all the pages of this thread bus since I'm not expert on OC, I need your preeeeeeecious help.

My system:

Mobo: Asus Maximus Extreme bios v.1001
CPU: Intel Q6600 (G0) cooled by Tuniq Tower 120
DDR3: CellShock 2x1Gb@1600Mhz 7-6-6-18 default settings
Wintows Vista x64


My bios settings:
OC From CPU Level Up:--------------------------Auto
OC From Memory Level Up:---------------------Auto
CPU Ratio Setting:--------------------------------09.0
FSB Frequency:------------------------------------370
FSB Strap to North Bridge:----------------------333Mhz
PCIE Frequency:-----------------------------------100

DRAM Frequency:-----------------------------------DDR3-1184Mhz
DRAM Command Rate:-----------------------------2T
DRAM Timing Control:------------------------------Manual
Primary Info: 6-5-5-15-4-40-8-4
CAS# Latency:------------------------------------6 DRAM Clock
RAS# to CAS# Delay:----------------------------5 DRAM Clock
RAS# Prechange:---------------------------------5 DRAM Clock
RAS# Active Time:--------------------------------15 DRAM Clock
RAS# to RAS# Delay:----------------------------Auto
Row Refresh Cycle Time:------------------------Auto
White Recovery Time:----------------------------Auto
Read to Prechange Time:-----------------------Auto
Secondary Info: 8-4-6-4-7-4-7
Read To Write Delay(S/D):----------------------Auto
Write to Read Delay(S):-------------------------Auto
Write to Read Delay(D):-------------------------Auto
Read To Read Delay(S):-------------------------Auto
Read To Read Delay(D):-------------------------Auto
Write To Write Delay(S):------------------------Auto
Write To Write Delay(D):------------------------Auto
DRAM Static Read Control:-------------------------Enable
DRAM Dynamic Write Control:---------------------Enable
Ai Clock Twister:-------------------------------------Strong
Ai Clock Skew for Channel A:---------------------Auto
Ai Clock Skew for Channel B:---------------------Auto
Ai Transaction Booster:----------------------------Disable
Relax Level:----------------------------------------1

CPU Voltage:------------------------------------------1.42500V
CPU PLL Voltage:-------------------------------------1.60V
North Bridge Voltage:--------------------------------1.35V
DRAM Voltage:-----------------------------------------1.90V
FSB Termination Voltage:----------------------------1.40V
South Bridge Voltage:--------------------------------1.075V
Loadline Calibration:----------------------------------Enable
CPU GTL Reference:-----------------------------------Auto
North Bridge GTL Reference:-------------------------Auto
DDR3 Channel A REF Voltage:------------------------Auto
DDR3 Channel B REF Voltage:------------------------Auto
DDR3 Controler REF Voltage:-------------------------DDR3_REF
SB 1.5V Voltage:----------------------------------------1.55V

CPU Spread Spectrum:---------------------------------Disable
PCIE Spread Spectrum:--------------------------------Disable


With those settings, I'm stable on prime for 3,5 hours....then, I'm dead!


Please treat me smooth since I'm "new kid on the block"