Official eVGA 780i Discussion/Review/Overclock/Guide Thread

[fadetoblack]

let us know what evga says.. although i havent had any issues in vista 64, i do have problems with nvgts.sys in xp 32 bit

[Skrips]

Ok, fellas, I need help. I have posted a help thread in the Itel support section, but since it pertains to this board I am posting a link to the thread I started to see if any of you super gurus can lend a helping hand!

Thanks in advance. The link to the other thread is here:

http://www.xtremesystems.org/forums/...d.php?t=177343


-Skrips

[Hughyhunter]

How do I manually set NB voltage? Is this the same as CPU FSB?

I have the voltages set to Auto for cpu and in cpu-z it says it is 1.32volts. Why is this higher than what others are getting in auto settings?

I flashed bios yesterday.... I have an E8400 on air and want 4.0ghz. I'm thinking I will set FSB to 1800 with a 9x multi. What voltages should I start with? I'm thinking since it says 1.32 in cpu-z it should be good for now.

Also I have sli enabled (expert) running linked with sync for memory. This should give me 900mhz. Do you think i'll need to loosen timings? Isnt the only other way to run 800mhz with an 1800mhz fsb to run unlinked and manually set speed? I'm new and need help.

memory is OCZ reaper pc6400 2X2 (that's why I need to know how to bump NB voltages) running at 1600fsb linked in sync mode with 4-4-4-15 timings.

Help me!!!

[X.T.R.E.M.E_ICE]

Whats the highest multi that this board supports for the QX9650?

[ncsa]

Have you tried the settings here outlined earlier? These are working with a QX9650 / Q6600 on an eVGA Board running the P03 Bios (XFX version)?

How do I manually set NB voltage? Is this the same as CPU FSB?

I have the voltages set to Auto for cpu and in cpu-z it says it is 1.32volts. Why is this higher than what others are getting in auto settings?

I flashed bios yesterday.... I have an E8400 on air and want 4.0ghz. I'm thinking I will set FSB to 1800 with a 9x multi. What voltages should I start with? I'm thinking since it says 1.32 in cpu-z it should be good for now.

Also I have sli enabled (expert) running linked with sync for memory. This should give me 900mhz. Do you think i'll need to loosen timings? Isnt the only other way to run 800mhz with an 1800mhz fsb to run unlinked and manually set speed? I'm new and need help.

memory is OCZ reaper pc6400 2X2 (that's why I need to know how to bump NB voltages) running at 1600fsb linked in sync mode with 4-4-4-15 timings.

Help me!!!

The QX9650 is fully unlocked on this board with current BIOS such as P03.

Whats the highest multi that this board supports for the QX9650?

[X.T.R.E.M.E_ICE]

The QX9650 is fully unlocked on this board with current BIOS such as P03.

So i will be able to use as high as 16x Multi sweet.