Quote Originally Posted by .OCX View Post

2 Hour Screenshot

400 STRAP
[BIOS SETTING]
Code:
Ratio CMOS Setting : 9
FSB Frequency : 444
FSB Strap to North Bridge : 400
PCI-E Frequency: 100
DRAM Frequency: DDR2-1186
DRAM Command Rate : 2T
DRAM Timing Control: Manual 
5-5-5-15
DRAM Static Read Control: DISABLED
Ai Clock Twister : STRONG
Transaction Booster : ENABLED
Boost: 0
Performance Level: 7

CPU Voltage : 1.28125v
CPU PLL Voltage : 1.5v*
North Bridge Voltage :1.61v 
DRAM Voltage : 2.34v
FSB Termination Voltage :  1.20v*
South Bridge Voltage : 1.05v*
Loadline Calibration : ENABLED
CPU GTL Reference : .61
North Bridge GTL Reference : .63
DDR2 Channel A REF Voltage : DDR2
DDR2 Channel B REF Voltage : DDR2
DDR2 Controller REF Voltage : DDR2
SB 1.5V Voltage : 1.5v*
*Lowest Bios Setting Available in 0907

-Added High CFM Fan directly to DRAM.
-Changed DDR2 Channel A & B REF Voltage to "DDR2"
-This increased the DRAM REF Voltage in Hardware Monitor from (Auto@1.184v) to (DDR2@1.23v)
-DRAM installed in White Slots to get around DETDRAM issues when Overclocking, helps overall DRAM Stability.
-Limited on 400 Strap due to RAM

-1.28125v VCORE is the Exact Same Setting I use for my 333 Strap Stable@ddr2-1068 that is also currently in use for this 400Strap Stable@ddr2-1186.
Man, running orthos is out of date, not to mention u were using priority 1... that is nothing!
If you want to stick witk Orthos, then run two instances of it, Small FFT's test, with priority 9!!
If your rig can take 5+ hours, then ur CPU probably able to that freq!

But still, i would recommend to use Prime95 v25.6!