I'm having trouble getting my memory to post.

I am trying 8x500 for and even 4.0. With all the memory settings on auto it boots up and passes Orthos Small FFT (16 hours) and Large FFT (7.5 hours)

But when I try to set the memory timings manually, it hangs at DET DRAM

When I run it with a 400 FSB it posts at 5-5-5-12 no problem. But at 1:1 with 500 FSB it only works on AUTO.


Extreme Tweaker
Ai Overclock Tuner : Manual
OC From CPU Level Up : AUTO
CPU Ratio Control : Manual
- Ratio CMOS Setting : 8
FSB Frequency : 500
FSB Strap to North Bridge : 400
PCI-E Frequency: 120
DRAM Frequency: DDR2- 1000
DRAM Command Rate : 2T
DRAM Timing Control: Manual
CAS# Latency : 5
RAS# to CAS# Delay : 5
RAS# Precharge : 5
RAS# ActivateTime : 18
(I had all of these settings manual on my Q6600, but haven't got there yet since installing the E8400)
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time : AUTO
Write Recovery Time : AUTO
Read to Precharge Time : AUTO

Read to Write Delay (S/D) : AUTO
Write to Read Delay (S) : AUTO
Write to Read Delay (D) : AUTO
Read to Read Delay (S) : AUTO
Read to Read Delay (D) : AUTO
Write to Write Delay (S) : AUTO
Write to Write Delay (D) : AUTO
DRAM Static Read Control: AUTO (Have tried with this on and still nothing)
Ai Clock Twister : AUTO
Transaction Booster : AUTO

CPU Voltage : 1.36875
CPU PLL Voltage : AUTO
North Bridge Voltage : 1.61
DRAM Voltage : 2.04
FSB Termination Voltage : 1.52
South Bridge Voltage : AUTO
Loadline Calibration : Enabled
CPU GTL Reference : 0.63x
North Bridge GTL Reference : 0.67x
DDR2 Channel A REF Voltage : AUTO
DDR2 Channel B REF Voltage : AUTO
DDR2 Controller REF Voltage : AUTO
SB 1.5V Voltage : AUTO

NB LED Selection : NB Volt
SB LED Selection : SB Volt
CPU LED Selection : CPU VOlt


CPU Spread Spectrum : Disabled
PCIE Spread Spectrum : Disabled

Advanced CPU Configuration
CPU Ratio Control : Manual
- Ratio CMOS Setting : 8.0
C1E Suppport : Disabled
CPU TM Function : Disabled
Vanderpool Technology : Disabled
Execute Disable Bit : Disabled
Max CPUID Value Limit : Disabled


USB Configuration
USB Functions: Enabled
Legacy USB Support : Disabled