If you get no POST, hold Insert and keep tapping Delete for a few reboots until you see the red error message and white writing below it, then hit F1 and you should be able to get into the BIOS.

I found something to note here =>

Underclocked my system, 2.3G/1.8G/800M CPU 1.175 VID 1.160V and IMC 1.050VID - all else the same at stock as before.

Power draw:
Idle = 90W AC (right now)
Load = 157W AC

Same as above but with CnQ enabled=>

Power draw:
Idle = 97W AC
Load = 159W AC



CnQ throws NB VID/voltage higher although it lowers CPU VID/voltage. Thus, manually setting low VID/volts gets me lower power than not. The power today is less because I have no HT/RD790 volts on today than earlier.

Quote Originally Posted by Daveburt714 View Post
Thanks KTE, I thought the dividers should work, but I haven't had much luck with them. I'm not done yet though...

I tried a few of the other Bios versions but reverted back to 1.13 myself.
Have you tried:

NB FID = 18
NB VID = 25
NB DID = 2 (is there such an option?)

Sorry to interupt you guys conversation, it's fun to watch the masters at work!! Even though I don't understand 1/2 of it, I'm learning...
Well I know one thing for sure.. I'm not a master at all, just a normal guy.

COF: Current Operating Frequency

NB speed has to remain minimum 0.5x CPU speed and maximum 32x CPU speed.

Not read the guide enough to see for any more details.

jonspd: Which exact settings are you after? Which BIOS are you on?