DDR2 Full Specs

[laragirl83]

Okay, I just received the answer from Super Talent support, in regarding to what kind of chips used on my T1000UB1G4 modules.

Here it is

Dear Customer,


Yes they are Micron D9 – not sure which batch though.


Best Regards,

Mark.Pedro@Supertalent.Com - MSN Messenger/ Email

Technical Support - SuperTalent.com

[Rone]

Okay, I just received the answer from Super Talent support, in regarding to what kind of chips used on my T1000UB1G4 modules.

Here it is

[...]

As I expected. Good luck with them!

[laragirl83]

As I expected. Good luck with them!

Hm, dont u know, is there a way, I could check out the sub-timings for these rams. I just dont want them run 10-10-10-11, IF I could go lower

Okay, i figured it out! In BIOS I set the timings "By SPD", aka automaic

Here it goes, not bad, iznit?

[necron66]

I'm no expert here, just learning myself, but PL12 is pretty bad?? On my P35 and x38 boards when at stock clocks and timings with ddr1066 ram I have a PL4 or mby PL5.

[Rone]

I'm no expert here, just learning myself, but PL12 is pretty bad??

Not necessarily bad, just default on many P965 boards. It's the same with my P5B Deluxe.

[laragirl83]

I'm no expert here, just learning myself, but PL12 is pretty bad?? On my P35 and x38 boards when at stock clocks and timings with ddr1066 ram I have a PL4 or mby PL5.

PL doesnt work on 965 chipset based boards when running 1:1 FSB/RAM ratio...
It only works when its 2:3 or 4:5 ratio in use...

[necron66]

Oh ok, I didn't know that.

[laragirl83]

Oh ok, I didn't know that.

Now you do!

Anyway, Perfromance Level aka. Static Read Control in BIOS can be set of course (disabled, auto, fast, faster)!
I did try it, just out of curiousity, set it to Faster! That gave under XP the PL to 10! Not much difference to 12 tough... I dont have to say, none of the benchmarks
showed improvement!
Another thing, in OC era, if you want to achive higher memory clock, Static Read Control (PL) should be set to disabeld.