My bad on the 95nm got a lap dog interfering with me , it is 90nm. Those temps are @ 3.52 full load Orthos X 1 hour. I just got the water block on, using the above described method. Neoprene hand cut gasket about 1/8" and it's rock solid (well rubber rock).

I'll have to get some time to run low multiplier high FSB tests to see if it's doing me any good. I ran it full load about a half hour and the NB was at 38C @ 220.
It was up around 53C if I'm reading the temps right. Been using AOD and Core Temp, and Speed Fan. What are you using to read it, and which one are you reading from so were on the same page.

That's probably not indicative of what you'll get temp wise, my Radiator isn't real great. Aluminum 1 1/2 thick, was a throw in to a trade so I'm using it until I can get a triple 120mm rad.

I took some installed pics, they should be up in about a half hour.