Post Rad Chiller Concept

[Martinm210]

Here is another day of milling, as usual just takes longer than I expected. Only managed to get the internals milled out.

My typical full of chips view....


Progress:


Now I need to start working on the bolts and barbs. I like waiting to finish the block exterior until it's completely assembled. The two pieces will be assembled with Yamabond liquid gasket so it'll be a semi-permanent seal. This is a liquid gasket material for assembling motorcycle engine cases, so it's very durable and can resist coolant, gas, oil whatever you throw at it.

And the mill is sure getting a bit messy, will have to spend a few hours cleaning up this mess... Anyone want some copper/acetal coleslaw?

I also recieved the 91Watt TEC's today, so it's coming together..