Official DFI LanParty UT X38-T2R(and LT) Discussion/Review/Overclock/Guide Thread

[zanzabar]

so why is tape being advised for mosfets i used mx-2 and they dropped to +3 ambient idle from +8 and i have more volts in them now, so why use tape with the semi hard mount the dfi dosnt have a gap from the push pins

[Aerou]

so why is tape being advised for mosfets i used mx-2 and they dropped to +3 ambient idle from +8 and i have more volts in them now, so why use tape with the semi hard mount the dfi dosnt have a gap from the push pins

great it worked for you, I will try myself with an MX-1

[Evil-Fruits|R4z]

Anyone know where to get one of these from in Europe?

HPM.de is out with no restocking date as yet and I'm desperate to get my hands on one.

Thanks
r4z

[eva2000]

so why is tape being advised for mosfets i used mx-2 and they dropped to +3 ambient idle from +8 and i have more volts in them now, so why use tape with the semi hard mount the dfi dosnt have a gap from the push pins

same here used MX-2 on my DFI X38 LT on SB/NB and PWM area and really nice low temps under load

this is the stock stuff (Shinetsu X23-7783D ?) which i removed - pretty well applied on PWM area



if it's Shinetsu X23-7783D, then its consistency is pretty much same as MX-2 TIM.