**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[politenessman]

I think you need to have latest bios but no need to mess with the jumper. I did just that and all my sata works properly. I reckon that's a software problem, not a sata connector malfunction.
No need to move the fsb jumper, just overclock via bios. Haven't seen anyone use the jumper to increase fsb. Perhaps you could only use it if you have some older cpu with less fsb than the newer 1066/1333MHz Conroes's or quads.

just flashed the latest official bios (12/24) and still n/g. intel matrix manager still says there are only 4 sata ports. is this a common fault, or it only hits a couple boards?

i see in this thread there is only one guy with this problem - orkan, post #413 page 17, and it doesnt look like he got a fix. i guess i can use the crappy j.micron for now its only an optical drive. but i might need those ports, also someday (soon) i am going to sell the board to swap to a 780i or 790i board for sli, this means i will have to rma it, again, i just got it back from friggin rma today, my first was doa. i havent got a doa part since about 2002. way to go, dfi qa.