Quote Originally Posted by aoch88 View Post
I used to have a DS3L and manage to get my E2140 Orthos stable at 435x8. However after switching to IP35 Pro, I can't even pass the 429FSB mark even I increased the MCH and ICHIO.

Any ideas what I missed out? There are indeed plenty of stuffs to configure in the BIOS and I don't raelly know what to add. I tried adding all but same thing.
the only gotcha on this board is the vdroop under load...it is about 0.04v under a load...so...you have to compensate with a higher vcore for idle conditions...remember, not every board is alike especially among different makers....i would only do that to complete orthos...after finishing lower for idle conditions....it's made easy with Uguru.

write out your voltages in your reply...also, it would be easier if you wrote out your specs in your sig.