Finally got my EK fullcoverblock in, (have to update my sig) it was a bit hard to get perfect contact but eventually i managed.
So, with a rediculous amount of bubbles in the loop i started rasing voltage and never saw over 43ºC full load.
The air has to bleed out which takes several days and the thermal compound (MXII) has to settle a bit so temps will go down and i have to say ambient was pretty high at the time of testing.
I was testing the floorheatingsystem so i reckon ambient was up to ~23+ºC, usually it's ~20ºC here.
So far at 912 core 2205 shader and 1128 memory ATItool ran without errors but after 2 minutes some yellow dots started to appear.
This was with 1.47V idle 1.51V load.
I could go a little higher on the core but 928 locked up in 3D, shaders could go as high as 2250 but started artifacting there.
All in all, only a brief test but i'm quite happy.
Reply With Quote
Bookmarks