ASUS Maximus Formula SE

[binormalkilla]

try lowering 42 to 30, maybe 25. I've experienced less latency with the everest benchmark with that

Yea I'll check it out....still going for max frequency ATM. TImings doesn't really do much for Intel bandwidth.....latency goes down some as you said.
Here is a bit of stability.....normally when it goes this far without errors then it will.....go.....all....the......way!

[ReZ_]

Yea I'll check it out....still going for max frequency ATM.

stability with memtest? why not use OCCT, prime95?

btw, did you get nice temp drops with the nozzles for the d-tek?

[binormalkilla]

stability with memtest? why not use OCCT, prime95?

btw, did you get nice temp drops with the nozzles for the d-tek?

Well I installed the nozzle when I first installed the block, so I had no standard for comparison :p
I use HCI Memtest to test the memory only....it will kick out an error faster than OCCT for memory only. I've already stability tested the hell out of my CPU at 3.8......plus I was browsing the internet and listening to music so I needed some CPU power. It says %100 in task manager, but it will allow other programs to take over around %5 CPU usage.....and I reserver around 15Mb or so of memory for my use.