Hey guys

Here are some graphs i'd like comments on...

also, my board doesn't run on anything besides 400strap. except for stock auto settings, which is 266strap. Broken dividers?

9x multi doesn't work for me, even when underclocked, tried various straps, memory speeds, voltages... wth?

3.6ghz is not stable yet, vcore is probably too low (i did up it a bit, along with other essentials), but i get high temps with my case on silent fan settings. Fans on high sound like a cheap hairdryer Temps are pretty high at 3.4ghz for my tastes, but i did hit 81c with ~1.41 vcore
I guess lapping is my only option left, I recently swapped my stock cpu block for a dtek fuzion with mx-2 paste. Temp dropped ~2c... not what i expected.

Any comment is appreciated!

Extreme Tweaker
Ai Overclock Tuner : Manual
OC From CPU Level Up : AUTO
CPU Ratio Control : Manual
- Ratio CMOS Setting : 8
FSB Frequency : 425
FSB Strap to North Bridge : 400
PCI-E Frequency: 110
DRAM Frequency: DDR2-1133
DRAM Command Rate : 2T
DRAM Timing Control: Manual
CAS# Latency : 5
RAS# to CAS# Delay : 5
RAS# Precharge : 5
RAS# ActivateTime : 15
RAS# to RAS# Delay : 3
Row Refresh Cycle Time : 30
Write Recovery Time : 5
Read to Precharge Time : 3

Read to Write Delay (S/D) : 8
Write to Read Delay (S) : 3
Write to Read Delay (D) : 5
Read to Read Delay (S) : 4
Read to Read Delay (D) : 6
Write to Write Delay (S) : 4
Write to Write Delay (D) : 6
DRAM Static Read Control: Enabled
Ai Clock Twister : Strong
Transaction Booster : Enabled [0]

CPU Voltage : 1.31875
CPU PLL Voltage : 1.56
North Bridge Voltage : 1.41
DRAM Voltage : 2.10
FSB Termination Voltage : 1.3
South Bridge Voltage : 1.050
Loadline Calibration : Enabled
CPU GTL Reference : 0.63x
North Bridge GTL Reference : 0.67x
DDR2 Channel A REF Voltage : DDR2-REF
DDR2 Channel B REF Voltage : DDR2-REF
DDR2 Controller REF Voltage : DDR2-REF
SB 1.5V Voltage : 1.50

NB LED Selection : NB Volt
SB LED Selection : SB Volt
CPU LED Selection : CPU VOlt
Voltiminder LED : Enabled

CPU Spread Spectrum : Disabled
PCIE Spread Spectrum : Disabled

Advanced CPU Configuration
CPU Ratio Control : Manual
- Ratio CMOS Setting : 8.0
C1E Suppport : Disabled
CPU TM Function : Disabled
Vanderpool Technology : Disabled
Execute Disable Bit : Disabled
Max CPUID Value Limit : Disabled


USB Configuration
USB Functions: Enabled
Legacy USB Support : Disabled





























Oh, here's a 10 hour OCCT run, with stock gigabyte waterblock. Ambient is 23c, which drops to 20c during the night, hence the gradual drop.