Official GIGA P35-S3/DS3/DS3R/DS3P/DS4/DQ6 bios/info thread

[sniper007]

Did you increase the mch voltage or fsb voltage? Try with both. What ram is that anyway? I've never heard of ddr800 to stop dead at 400 mhz rated speed.

Dunno about e2140's but i can't think it has such a low fsb wall. What vcore for cpu?

What bios version?

Thankyou for your quick reply AriciU

BIOS Version F6 (I am only using this because it shipped with it - otherwise seems fine).

CPU Vcore currently at 1.35 but as I say, I don't think it needs this much to get 3.2ghz stable. Will probably be ok with 1.325 or 1.300. I tried inreasing FSB voltage by one notch as well and dint make a difference. I can try two notches but I would be surprised if it needed 0.2+ on NB just to get to 810mhz! Tried increasing DDR2 voltage as well right up to the max rated 2.3v.

The ram is the ram that all us UK people have been buying at ocuk for dirt cheap! I did research the ram before I bought it though, and it was apparent that it was the least problematic on my board and was good stable ram that was great value for money as it DOES overclock ok as well. Its commonly used ram over here.