Thanks again for the help guys! I came up with one idea that I wanted to run by you guys regrading my power issue. The absolute first time I powered up the board I had connected all the normal power connectors (ATX, 12v 8-pin, and 2x 6-pin GFX connectors) but I also plugged in one of the two 4-pin floppy connectors (for when running 2x graphics cards). After I setup my RAID 0 array and did a once-through on the BIOS I shut the board done and removed that 4-pin connector (because I read through the Users Manual which said those 4-pin connector should only be used when 2x cards are installed). Could plugging in that additional 4-pin connector have caused this issue I'm having now with the Nvidia Power Sentinal? After everything I have checked out and read about this is the only thing I can figure would cause this?