Quote Originally Posted by Caped Crusader View Post
Got my new G.Skill 8000 PQ 4Gb and I would like to share timings and settings with you guys (with anyone who has this babies at least).

I'm running an E6750 @ 450x8 = 3600Mhz with vcore 1.35v (Everest says 1.34v, CPU-Z flutuates between 1.328 and 1.344)
RAM with 2.40 divider @ 1080Mhz with 1.98v

Everest timings dump:

Memory Timings:

CAS Latency (CL) 5T
RAS To CAS Delay (tRCD) 5T
RAS Precharge (tRP) 5T
RAS Active Time (tRAS) 15T
Row Refresh Cycle Time (tRFC) 54T
Command Rate (CR) 2T
RAS To RAS Delay (tRRD) 5T
Write Recovery Time (tWR) 17T
Read To Read Delay (tRTR) Same Rank: 4T, Different Rank: 6T
Read To Write Delay (tRTW) 8T
Write To Read Delay (tWTR) Same Rank: 13T, Different Rank: 5T
Write To Write Delay (tWTW) Same Rank: 4T, Different Rank: 6T
Read To Precharge Delay (tRTP) 7T
Write To Precharge Delay (tWTP) 17T
Refresh Period (tREF) 4213T
DRAM Read ODT 3T
DRAM Write ODT 6T
MCH Read ODT 8T
Performance Level 7
Read Delay Phase Adjust Neutral
DIMM1 Clock Fine Delay 7T
DIMM2 Clock Fine Delay 7T
DIMM3 Clock Fine Delay 8T
DIMM4 Clock Fine Delay 7T

I got a blue screen just half an hour ago while browsing some photos... Everest stress test won't crash within 5min. Maybe is the memory too tight and bluescreening my system?

Thanks in advance for your feedback.
First of all, i seriously doubt you can run the E6750 at 1.35v at 3,6ghz. I bet you'd have to up it to atleast 1.45v. I have the same cpu and i need 1.55v to be 100% stable on this board.

Also, memory is very touchy about running past 1066 on this system when using more than 1 module,- especially when using more than 2. I'd try 5-7-7-24 and up DDR voltage to 2.25

Get OCCT. If you can go past 2 hours in it without crashing you're most likely stable.