Originally Posted by emoners
at or below 1.52v it was spot on...in fact, cpuz ver. 1.42 adds the thousands place, which is extremely close to DMM readout...once i went above 1.55v, it was slightly off..ie., when i set the vcore to hold 4.5 ghz cpuz and SG were about 0.005v low...obviously, not TO shabby!...close enough for me!
this is going to be it for me 4.5 ghz @ 1.573 Vcore...i probably can push this higher but it will require at least 1.60+ vcore to go to 4.6 ghz...also, the reboot and cold power on post might be solved by jamming on higer than i anticipated NB voltage...the board powered on normally this morning after returning from a trip to the store...if you notice the NB is at 1.66v...i think it is actually a little higher when i boot into the bios to read it.
here is my 4.5 ghz.
Reply With Quote
Bookmarks