Ok well I just did my first pencil vmod. The-strokes...thanks for that pic.

Stock resistance on the one resistor was 2.66....brought it down to 2.41 but my PCB is a bit different and don't know where to measure the vgpu. Hopefully I'm not roasting it?

Anyway so far it's stable @ 891/1080 ....temps don't go over 40c

I also have a question....I am using CCC to overclock and atitool to scan for artifacts. Ever since I unlocked overdrive I haven't been able to set my clocks with ATiTool....they just revert back to whatever I have set in CCC....and my CCC slider only goes to 900mhz.

1) Is there any way to extend the slider range in CCC?
2) How can I use ATITool to set my clocks again?