Hi all, I see a few that want a picture taken AFTER the vGPU mod has been done.
I can provide that because I understand what to do, I have a 3870, I have very good experience with soldering small
components (even SM-components) and of course I have a camera and a webhost..
The only thing I'm missing is a VR of 100kOhm. It's sunday here and EVERY store is closed.
I will ask my friend at work tomorrow for a 100kOhm VR.
Even though I have stock cooling on right now I have a EK waterblock on order so that should be settled in a couple of days.
When I'm done with the mod I will try to take several pictures and help out as much as possible.
Ohh, I have one question though, when I'm done with the mod and everything is ready to go!
How do I know where to start with the VR.
Is it just a matter of trial and error? To start with it set to max resistance (100kOhm) and then
slowly turn it "down" and measure the vGPU readout until I get what I want (about 1.5v)?
I have actually pretty good knowledge in soldering and electronics but have never done a vMOD of this kind before
##EDIT##
I have to chose from one of the following ones, any opinions?
type 44 Y for SM with only 10 turns
type 64 with 15 turns
Type 67W with 20 turns
Type 89P with 20 turns
Reply With Quote
Bookmarks