WC in an Antec P182--> rad inside?

[xackitt]

I have a P182SE with an MCR320 2 fans internal and 1 external this is primarily due to the way my board is setup

The pump is in the very bottom and the res outside. You could go without a res if you wanted, or a bay res would be fine too.

Since I'm not so good with drilling holes etc., the radiator on top isn't my favourite idea... I do like it though .

Looker: could you measure the length between your psu and front of the case.. you think it's possible to put the rad there?

I put a PA120.3 down there once, much like the TJ07 style way of doing it.

It didnt go well.

How come?