**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[Ace-a-Rue]

well i just fired up my abit p35 pro,e6750 cpu,and ocz reaper 8500 ram 2x1 gig
i am using an ultima90,with a 92 and 120 push pull,it is just setup on my desk,for now.
i went into bios,made a few changes,ram timings voltages etc.
when i leave bios,why does it turn off,then start back up again?.i have never encountered that before?
fwiw,cpu temp in bios was reading 23c!!
look forward to this new bios

are you using beta bios 16.b01?...that should cut down on the board shutting down when you make minor changes...my board still shuts down when i jump into a new memory strap or i change multi....all other changes, as i remember, do not shut the board down.

[jtf2]

are you using beta bios 16.b01?...that should cut down on the board shutting down when you make minor changes...my board still shuts down when i jump into a new memory strap or i change multi....all other changes, as i remember, do not shut the board down.

the bios i have is what was shipped with the board-14.
i have looked at the 16 bios,and i have a ? about it.
why does it not have a .bin filename,
it reads M629B 16AT.B01.
thanks

[new-b]

the bios i have is what was shipped with the board-14.
i have looked at the 16 bios,and i have a ? about it.
why does it not have a .bin filename,
it reads M629B 16AT.B01.
thanks

Any bios that ends in .B0x means it's a beta bios.

[Ace-a-Rue]

the bios i have is what was shipped with the board-14.
i have looked at the 16 bios,and i have a ? about it.
why does it not have a .bin filename,
it reads M629B 16AT.B01.
thanks

correction on multi change shutting the board down...on my board with beta 16.b01, a multi change does NOT shut the board down...i have the original version 1.0....changing memory timings and memory straps will shut the board down.

beta bioses done by Abit end in a letter and 2 numerical numbers instead of the normal ".BIN" so people know that it is not an official bios...beta's are still in the tweaking stage so things might not work perfectly.