OCCT 1.2.0b has been vital for me in getting voltages under control and in so doing has brought the stability "DRAGON" that I've been so hard at chasing. I've pretty much found my lowest voltages with the exception of maybe some more vNB, but I already have it nice and low. Here is what I'm running right now. I'm going to run this OCCT for 12 hours and see how it does.
400x9 DDR 800 4-4-4-12
Code:BIOS 701 Extreme Tweaker Ai Overclock Tuner : Manual OC From CPU Level Up : Auto CPU Ratio Control : Manual -Ratio CMOS Setting : 9 FSB Frequency : 400 FSB Strap to North Bridge : 400 PCI-E Frequency: 100 DRAM Frequency: 800 DRAM Command Rate : 2T DRAM Timing Control: Manual CAS# Latency : 4 RAS# to CAS# Delay : 4 RAS# Precharge : 4 RAS# ActivateTime : 4 RAS# to RAS# Delay : 12 Row Refresh Cycle Time : Auto Write Recovery Time : Auto Read to Precharge Time : Auto Read to Write Delay (S/D) : Auto Write to Read Delay (S) : Auto Write to Read Delay (D) : Auto Read to Read Delay (S) : Auto Read to Read Delay (D) : Auto Write to Write Delay (S) : Auto Write to Write Delay (D) : Auto DRAM Static Read Control: Enabled Ai Clock Twister : Light Transaction Booster : Disabled -Relax Level 0 CPU Voltage : 1.38750 CPU PLL Voltage : 1.54 North Bridge Voltage : 1.49 DRAM Voltage : 2.00 FSB Termination Voltage : 1.26 South Bridge Voltage : 1.050 Loadline Calibration : Enabled CPU GTL Reference : 0.63x North Bridge GTL Reference : 0.67x DDR2 Channel A REF Voltage : Auto DDR2 Channel B REF Voltage : Auto DDR2 Controller REF Voltage : DDR2-REFF SB 1.5V Voltage : 1.50 NB LED Selection : NB Volt SB LED Selection : SB Volt CPU LED Selection : CPU Volt Voltiminder LED : Disabled CPU Spread Spectrum : Disabled PCIE Spread Spectrum : Disabled Advanced CPU Configuration CPU Ratio Control : Manual - Ratio CMOS Setting : 9 C1E Suppport : Disabled CPU TM Function : Disabled Vanderpool Technology : Disabled Execute Disable Bit : Disabled Max CPUID Value Limit : Disabled USB Configuration USB Functions: Enabled Legacy USB Support : Enabled
Bookmarks