NBStrap set to 400 and DRAM Frequency set to the middle setting. at 400 FSB it will be 800. So it will be 2x your FSB. That will be 1:1. You are just overclocking the RAM to high leaving it on auto. I really don't like anything set to auto.
Edit: Also avoid the urge to change a lot of settings when finding your OC. That will give you more headaches than you want. Just take the time and adjust one thing at a time. Of course ram timings usually have serveral settings changed when you are adjusting things. Everyone has their own method to finding their OC. I used to use Prime95 for 10 minutes. Now I use OCCT for 10 minutes and then tweak the same setting again (usually going down in voltage) going down in 2 incraments until i either error or it won't post. If I get hang up/no post then I turn puter off and then restart as sometimes the settings don't go into effect properly and a full power down (cold boot) is required and it works just fine. Once I get an error I go up one and run a 20 min test then move onto tweaking another setting. It's time consuming but has helped me with stability greatly on this board.
Reply With Quote
Bookmarks