Quote Originally Posted by Clunk View Post
No mate, it is absolutely stock. Normally, I would have taken it off, and replaced with something else, but I didnt have anything that would fit - Being realistinc though, the PWM cooler is flawed, in so much as it really needs a fan to cool it, but unless you go out and buy one, the board will overheat relatively quickly.

I have seen 112c on the PWMs when only using 1.5v, and that was with a 92mm fan directly on the heatsink, and the board was built up out of the case.

I'm returning mine on monday, it has no redeeming features.
what i was talking about for the heatsink is yanking it and removing the TIM pads to replace with Ceramique along with using a bolt/nut, where the plastic push-pins with springs are used, to get better clamping action and therefore, better heat dissapation.