Quote Originally Posted by mnaz View Post
Ok just got this board setup to replace my p5k deluxe which died. With my two ballistix I get a C1 error. When i try to boot and with one of them I get the C1 error when it is by itself the other I do not. Dead stick most likely? I did set the timings and voltages manually in the bios.

its most likely a dead stick when i put in my ballistix from my dead p5b-deluxe it wouldnt boot, rmaed it and put in the new sticks and it boots fine without any errors.


also is the vdroop on this board that bad? on my p5b i only had to set 1.45v to get my e6600 stable at 3.6 but on this board i had to set it at 1.48. i dont have a multimeter so i cant really see what the "real" voltages are but uguru jumps from 1.46ish idle to 1.42/1.45 load.