Well I installed my ultra 120 extreme and the temps are ok, but I had to take my side 250mm fan off my thermaltake armor case. I have two more 120mm intake fans for the front arriving today, and I have another 120mm with clips for a push/pull setup.
Well I installed my ultra 120 extreme and the temps are ok, but I had to take my side 250mm fan off my thermaltake armor case. I have two more 120mm intake fans for the front arriving today, and I have another 120mm with clips for a push/pull setup.
Q6600 G0 @ 3.8 (475x8) 1.496V || ASUS Maximus Formula X38 || 4x2GB Geil Evo One DDR2-950 5-5-5-15 ||
Sapphire 4870X2 857/1000 || XSPC Delrin full coverage block || MCP655 || D-Tek Fuzion Nozzled ||
Black Ice 480GTX 8 120mm Yate Loon push/pull || Silverstone DA850 PSU 70A +12V || Auzentech Prelude ||
Vantage P15071 in Vista x64
Well I did tell you that it was big . You should have got the ultima-90 its baby brother which almost holds the same temps. If you had got that you could have kept the 250mm fan and had the same temps near as damn it. I have a cheap eZcool h550 case which also has a 250mm fan on the side panel which is why I got the ultima - no headroom for bigger HSF. But in this case bigger isnt a lot better-lol!. What fans did you get - the sythe sflex , panaflow or Silent eagle 2000 all have high CFMs and are reasonably quiet. did you take the opportunity to check that the IHS and HS are flat when you fitted the 120?
Q6600 - L729A959
VID1.2625 @3.72GHz (465x8) 1.4625v(BIOS)
P5K Premium (0702 BIOS)
Win7 Ultimate x64
Ultima-90
4x1GB Ballistix 8500C5 @ 1166 5-5-5-12 2.2v
MSI 5770 Hawk 1030/1330 - 1.25v
2 x Hitachi T7K500 320MB - Matrix RAID 0/1
Hiper Type R 680w
Just got this one last night. Fired up at 3.6 at 1.35v real 6+ hours prime.
Will test further over next few days.
MB Reviewer for HWC
Team OCX Bench Team
It's not a big deal at all. I installed my icages (3 120mms for intake) and I ran Prime95 for 4 minutes to test temps. I then installed the 250mm fan on the outside of the case and the temps were exactly the same.....so no big deal. I'm sure after a long period of time running prime the heat will build up, but my second 120mm fan for the CPU will fix that![]()
Q6600 G0 @ 3.8 (475x8) 1.496V || ASUS Maximus Formula X38 || 4x2GB Geil Evo One DDR2-950 5-5-5-15 ||
Sapphire 4870X2 857/1000 || XSPC Delrin full coverage block || MCP655 || D-Tek Fuzion Nozzled ||
Black Ice 480GTX 8 120mm Yate Loon push/pull || Silverstone DA850 PSU 70A +12V || Auzentech Prelude ||
Vantage P15071 in Vista x64
L720B024
Q6600
GB X38
Water cooled MP05SP LE Ambient ~ 12-13*C
1.7V 4213mhz 3dmark 2003
Single 8800gtx@730/1944/2322 mhz
3Dmark2006
http://service.futuremark.com/compare?3dm06=3633135
6652 cpu score on water![]()
3Dmark2003
53600
And wprime 1024m stability 4206mhz 467x9 from BIOS
![]()
Last edited by DStealth; 11-04-2007 at 09:27 PM.
Very nice OCbut don't your hands get cold working in such a cold room
![]()
Q6600 G0 @ 3.8 (475x8) 1.496V || ASUS Maximus Formula X38 || 4x2GB Geil Evo One DDR2-950 5-5-5-15 ||
Sapphire 4870X2 857/1000 || XSPC Delrin full coverage block || MCP655 || D-Tek Fuzion Nozzled ||
Black Ice 480GTX 8 120mm Yate Loon push/pull || Silverstone DA850 PSU 70A +12V || Auzentech Prelude ||
Vantage P15071 in Vista x64
Bookmarks