Quote Originally Posted by Scope666 View Post
I’m in RAM Hell. When I first got this board, both of my Ballistix were randomly testing bad in Memtest86+ One stick all the time, the other only after the machine had been on for a few hours. So I put an RMA request in for them, and picked up a pair of Corsair XMS2 sticks to hold me over until the Ballistix get back. First set of Corsairs, BOTH sticks test bad (different bit locations for each stick, swapped slots and verified it wasn’t the motherboard or the slot itself)

So I returned those 2, got ANOTHER 2 Corsairs, 1 of the 2 is bad. Keeping the good one and hoping CompUSA won’t bust my chops about swapping out just the one bad one today. Anyone else running these sticks? Have you had problems? What volts do you guys run these at. They’re rated at 1.9 which sounds low compared to the 2.2 the Ballistix are rated at. At the moment just trying to run them at their rated timings and speed. (DDR2 800 5-5-5-15 timings)

Thanks in advance for any assistance. 
That sounds very much like the problem I have.
I sent in both the RAM and the motherboard for RMA.
I'm using the same Ballistix and got errors for all of them (Memtest86+).

Strange thing is when I tried some OCZ PC2-8500, it worked just fine with no errors at all.

I'm getting them back today and I will see how it goes.
The Ballistix I have are PC2-8500 5-5-5-15 and I have 4x1GB but I tried just two at a time and still got errors.