The voltages I used are really not optimized for 24/7 use. I was doing some testing/looking at waveforms so I jacked voltages up to a level I know would not be a stability issue while I was working with the board. NB and VTT were the only non-default voltages used. Nb - 1.61 and VTT - 1.60 with GTL at 112/112/115. On this board at the current speed NB GTL is the critical setting. I can change it a couple of points and the board will reboot while running Prime within a matter of minutes.

@terroristone

If you're using the memory in your sig there's no reason why the board shouldn't boot with default settings.