**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[the_real_7]

Hey Noobstorm
I get this issue all the time whenever the board has been powered down from the power supply over couple hours
I originaly thought this board was bad then found out some power supply's dont send a strong enough signal but i have a good power supply so that wasnt the issue, heres what i do now to get it back up it takes some patience but im sure your board will start, may get on the first try, make take a couple of hours, but if it hook up right and your power supply is working , itll start
1. move one stick of ram to any slot i pick the first or third but have booted on all
2.erase the cmos for 20m in with power supply off and no light on board
3.put battery back in wait another five minutes, and start
4.probably didn't start don't worry :P yet
5.next hold power button and power up main supply again do 5 or 6 time if the fans start power up and turn off continously just wait now another couple of min then try start aging to the board stays on

seems to be some wierd cold boot issue thought my board was dead three time's allready especialy since one time i got water on it but she always starts eventualy and runs solid

DFI LP UT P35-TNR
Intel Quad Core q6600 slacr 8/03/07 1.35v Fusion block
G.Skill F2-6400PHU1-2BHZ
cORSIAR HX 620W
EVGA 8800GTS A3 Core DD Full Block
Seagate 250 gig sata Raid-0
Seagate 250 gig sata Raid-0
Seagate 250 gig jbod
Seagate 400 gig jbod
Creative x-fi
Onboard Nic