Quote Originally Posted by GLENBOY View Post
hi there yes personally with myself i have a higher vcore and use 1.5125 volt and its 100% stable also on ram i am usinf 1/1 divider i have the old board as well with a max fsb volts 1.65, the e6850s run very well in this board
Thanks for the reply. I'm not exactly sure what revision I have - where do I check? I assume it's a later one, as my MCH goes up to 1.85v IIRC.

Also, what about my question of what you think I would gain by going to the modded GO BIOS? Do you think that would help the most to tighten up the ram timings? As it sits right now, I know it is only Orthos stable for 30+ minutes. I don't normally OC it, but I need to make sure it's totally stable there before I leave it OC'ed to 3.6 GHz +.