D-tek nozzles

[Talonman]

Plate can go either way as long as it avoids contact with nearby components.

Thanks for the reply Jedda.

wont the orientation of the quad nozzle make a big difference? Like if you split the flow 90 degrees rotated the wrong way, results would be poor.

Yes it will, and says so in the included instructions.

We are diverting the water directly onto the 2 dual cores.

I had the AS info page up on How to apply Céramique
Intel Quad Core CPU W/Heatspreader, looking at the orentation of the line (page 5).
http://www.arcticsilver.com/pdf/appi..._quad_wcap.pdf

Our included instructions with the Nozzle kit has the line going the oppisite way.

I think I have it right, and hoped the pic might help others on their install too.

But, yeha... Putting it the wrong way would probably cost you a few C.

I think if your mobo is orentated like mine when you mount it, just remember horizontal line on the nozzle, and vertical line for the AS goop is best.