Quote Originally Posted by largon View Post
Well this is odd.
Tested voltage stability with 3DMark06 on gaming stable freqs of 729/1890/2160:
1.36v (1.33v after droop): OK
1.54v (1.51v after droop): instant GPU powerdown
Maybe it's shuts down from over temperature protection or something....

Quote Originally Posted by T_M View Post
George, I have soldered a 100k on my 8800 Ultra.
As i trim, it starts from high resistance and goes down.
Once i reach ~7.57k it suddenly jumps down to ~3.362k.

Is the objective to raise the resistance across that resistor? If so, is 7.6k to ground OK?
Are you sure you have soldered to the same resistor?......If you have soldered an 100K trimmer, even fully opened, it shouldn't show you more than 5.12K.....

Quote Originally Posted by wittekakker View Post
Seems to be working great here, just ran 1.6V 3D, that is 1.7V 2D with my 8800GTS

Thx for sharing Shamino!

EDIT: hmm, still can't beat 720/1600/1040, protection kicks in at higher clocks :/
Same here too - Maybe it's shuts down from over temperature protection or something....